RT info:eu-repo/semantics/article
T1 Analysis of Modern Optical Inspection Systems for Parts Manufactured by Selective Laser Melting
A1 Giganto Fernández, Sara
A1 Martínez Pellitero, Susana
A1 Cuesta González, Eduardo
A1 Meana Díaz, Víctor Manuel
A1 Barreiro García, Joaquín
A2 Ingenieria de los Procesos de Fabricacion
K1 Ingeniería mecánica
K1 Optical measurement systems (OMSs)
K1 Dimensional and geometrical accuracy
K1 Metrological comparison
K1 Non-contact inspection
K1 3D scanning
K1 Additive manufacturing (AM)
K1 Selective laser melting (SLM)
K1 3312 Tecnología de Materiales
AB [EN] Metal additive manufacturing (AM) allows obtaining functional parts with the possibility of optimizing them topologically without affecting system performance. This is of great interest for sectors such as aerospace, automotive, and medical–surgical. However, from a metrological point of view, the high requirements applied in these sectors constitute a challenge for inspecting these types of parts. Non-contact inspection has gained great relevance due to the rapid verification of AM parts. Optical measurement systems (OMSs) are being increasingly adopted for geometric dimensioning and tolerancing (GD&T) verification within the context of Industry 4.0. In this paper, the suitability (advantages and limitations) of five different OMSs (based on laser triangulation, conoscopic holography, and structured light techniques) for GD&T verification of parts manufactured by selective laser melting (SLM) is analyzed. For this purpose, a specific testing part was designed and SLM-manufactured in 17-4PH stainless steel. Once the part was measured by contact (obtaining the reference GD&T values), it was optically measured. The scanning results allow comparing the OMSs in terms of their inspection speed as well as dimensional and geometrical accuracy. As a result, two portable systems (handheld laser triangulation and structured blue-light scanners) were identified as the most accurate optical techniques for scanning SLM parts.
PB MDPI
LK https://hdl.handle.net/10612/17820
UL https://hdl.handle.net/10612/17820
NO Giganto, S., Martínez-Pellitero, S., Cuesta, E., Meana, V. M. & Barreiro, J. (2020). Analysis of Modern Optical Inspection Systems for Parts Manufactured by Selective Laser Melting. Sensors, 20(11), 3202. https://doi.org/10.3390/s20113202
DS BULERIA. Repositorio Institucional de la Universidad de León
RD 05-jun-2024